HySecure Gateway Installation for HyLabs

Overview

This section outlines the configuration process for setting up the HySecure Gateway is specifically for HyLabs deployment environments. The HySecure Gateway serves as the secure access component within your HyLabs infrastructure.

Installation Process

The HySecure Gateway installation for HyLabs follows the standard deployment procedure used for other delivery types. However, there are important considerations specific to HyLabs implementations.

Prerequisites

Before beginning installation:

1. Sizing Assessment: Ensure your HySecure cluster is properly sized to accommodate your expected user load and traffic patterns.
2. Network Requirements: Verify that all necessary ports and network paths between HySecure components and other HyLabs systems are available.
3. Authentication: Prepare Security Officer credentials for the post-installation configuration.

Installation Steps

1. Deploy the HySecure cluster according to the standard installation procedure documented in the HySecure Knowledge Center.

2. Complete the basic cluster configuration, including:

3. Network settings.
4. High availability configuration (if applicable).

5. Initial security parameters.

6. For comprehensive information about HySecure deployment options and advanced configurations, refer to the HySecure Technical Introduction.

HyLabs-Specific Configuration

Once the base HySecure installation is complete, configure the system specifically for HyLabs delivery:

1. Access the HySecure Management Portal using Security Officer credentials.
2. Navigate to the HyLabs integration section.
3. Configure the necessary parameters for HyLabs connectivity.
4. Set up the appropriate access policies and user authentication methods.

Next Steps

After completing the HySecure Gateway installation, proceed to configure other HyLabs components as outlined in the HyWorks documentation.

For troubleshooting assistance or additional configuration guidance, contact Accops technical support.