Upgrade Old (last) Active Cluster Manager Node

1. Connect to last Active HySecure Cluster Manager node as Security Officer.

   Note

   1. Do not connect using Virtual IP Address.
   2. This node is already out of cluster and must be in maintenance mode (on HA page) and Configuration state (on HySecure Status page).

2. Go to Host Maintenance > Upgrade Firmware and upload the HySecure Upgrade patch file. It may take sometime to upload the upgrade patch based on network bandwidth between your PC and Gateway.

3. Once the upgrade file is uploaded and upgrade will start automatocally. Refresh the browser and check if the upgrade has completed.
4. Check the Gateway version on the Dashboard to confirm that the upgrade has completed.

5. Go to HA Configuration page and disable the Maintenance mode and verify that all services status is shown as OK.

   Note

   After above step, this node should become the standby node in the cluster and status of full cluster should be visible on the dashboard.

6. Ensure that the node has joined the cluster as standby.