Restart the cluster

1. Do the HA Failover
   

   1. connect to [Active] HySecure Cluster Manager node as Security Officer.

      Note

      Do not connect using Virtual IP Address.

   2. go to HA Configuration page put the HySecure node in Maintenance Mode. This gateway node will now not be part of the cluster and none of the nodes in the cluster will show the status of cluster.

   3. go to HySecure STATUS > HySecure Gateway State and put the HySecure gateway in Configuration Mode.
   4. logout from HySecure client.

2. Make New Active Node ready

   1. Connect to Standby HySecure Cluster Manager node as Security Officer.

      Note

      Do not connect using Virtual IP Address.

   2. Go to HySecure STATUS > HySecure Gateway State and put the HySecure gateway in Run Mode.

   3. You will be logged out automatically from HySecure client. Re-login into HySecure client as Security Officer.
      

   4. Go to HA Configuration page:

      1. disable the Maintenance mode.

         

      2. verify that all services status is shown as OK.

      3. disconnect Active HySecure node from the network or shutdown the Active HySecure node by connecting to HySecure Management console from HySecure OS Shell of Active.
      4. after few seconds, the Standby HySecure node has become "Active".

3. Make Dedicated Gateways join cluster again and ready to accept connections
   

   1. login into each Dedicated HySecure Gateway Node as Security Officer.

   2. go to HA Configuration and disable the Maintenance mode and verify that all services status is shown as OK.

   3. Repeat above steps for each HySecure gateway nodes.

4. The cluster should be up now.