Auto Backup

User and System backup can be generated automatically and be mailed or sent to an FTP location.

To check the state of the auto-backup module and configure automatic backup:

  1. Log on to the Management Console.

  2. Go to Settings > General Settings > Auto Backup.

  3. STATUS indicates the current status of the auto-backup module. It could be Running or Stopped. Change the status by clicking Start or Stop. An auto backup will not be initiated if the module is in the stopped state.

  4. Configure User Backup settings. This enables auto-backup of User Settings Only.

    Field Description
    Enable Check this option to set automatic backup for User Settings.
    Mode of communication Select the mode of sharing backup as either FTP or Email.
    Backup Interval (hrs) Enter the interval at which the backup is to be taken and sent as per the configuration.

  5. Configure entire system backup settings.

    Field Description
    Enable Check this option to automatically take the backup of the entire System.
    Mode of communication Select the mode of sharing backup as either FTP or Email.
    Backup Interval (hrs) Enter the interval in hours, at which the backup needs to be taken and sent as per the configuration.

  6. Database Backup: The HySecure administrator has to make sure that backups are taken regularly and in case of any backup absence, an un-towards failure is used to lead to a total reconfiguration of the gateway. To avoid such situations, database backup is enabled by default with 10 last backups and is taken at an interval of 24 hours. Click to enable this automatic database backup. Depending on the requirement, change backup interval and number of last backup files that are to be preserved.|

  7. Email Settings: Set up email addresses for sending backup files via email. The backup file can be mailed to all the registered administrators and Security Officers on HySecure or to the specific email IDs.

    Field Description
    Send email to all Admin users and Security Officers Check this option, if the backup needs to be sent over an email to all administrators and Security Officers configured in HySecure.
    Send email to additional users
    (specify ";" separated email list)    		 Enter ";" separated list of email IDs to whom the auto backup needs to be sent.

  8. FTP Settings: The configuration backup can also be sent to an FTP site.

    Field Description
    Username Enter the username to be used to connect to the FTP server.
    Password Password for the username to be used to connect to the FTP server.
    URL FTP server URL that is to be connected to upload the backup file.
    FTP Mode By default this is set to Passive and cannot be editable.

  9. Click Submit to save the configuration.