Upgrade Old (last) Active Cluster Manager Node

1. Connect to the last Active HySecure Cluster Manager node as Security Officer.

   Note

   1. Do not connect using a Virtual IP Address.
   2. This node should already be out of the cluster and must be in maintenance mode (on the HA page) and Configuration state (on the HySecure Status page).

2. Navigate to Host Maintenance > Upgrade Firmware and upload the HySecure Upgrade patch file. It may take some time to upload the upgrade patch based on the network bandwidth between your PC and Gateway.

3. Once the upgrade file is uploaded the upgrade will start automatically. Refresh the browser and check if the upgrade is complete.
4. Check the Gateway version on the Dashboard to confirm the upgrade completion.

5. Navigate to the HA Configuration page then disable the Maintenance mode and verify that all services status is shown as OK.

   Note

   After the above step, this node should become the standby node in the cluster, and the status of the full cluster should be visible on the dashboard.

6. Ensure that the node has joined the cluster as Standby.